TheBackShed.com

Home	JAQForum Ver 24.01
Log In or Join
Active Topics
Local Time 02:07 23 Nov 2024	Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : BASIC Speed Benchmark Tests

Page 8 of 8

Author

Message

Volhout
Guru

Joined: 05/03/2018
Location: Netherlands
Posts: 4221

Posted: 06:04am 10 Oct 2024

Copy link to clipboard

Print this post

Wauw,

I once did a project in F84 (Forth for the PIC16F84).
It ended up being a real nice working product, and actually the development time was not bad (given that I did not have any knowledge about Forth when I started).

But, same as above, the code is hard to understand. I really have to take out my HP11C calculator, make a few calculations, to get back into RPN (Forth is RPN) and go from there.

Volhout

PicomiteVGA PETSCII ROBOTS

PhenixRising
Guru

Joined: 07/11/2023
Location: United Kingdom
Posts: 855

Posted: 07:28am 10 Oct 2024

Copy link to clipboard

Print this post

Volhout said Wauw,

I once did a project in F84 (Forth for the PIC16F84).
It ended up being a real nice working product, and actually the development time was not bad (given that I did not have any knowledge about Forth when I started).

But, same as above, the code is hard to understand. I really have to take out my HP11C calculator, make a few calculations, to get back into RPN (Forth is RPN) and go from there.

Volhout

Often referred to as a write-only language

Page 8 of 8

Print this page

To reply to this topic, you need to log in.