Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 11:46 05 Dec 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : PCB Manufacturing : AutoTRAX DEX Tips and ideas

     Page 2 of 2    
Author Message
MicroBlocks

Guru

Joined: 12/05/2012
Location: Thailand
Posts: 2209
Posted: 04:51am 20 Jun 2018
Copy link to clipboard 
Print this post

Hi plover,

I did not get the castellated edges as they were very expensive. (about 100USD more for an order)

If your quantity is high enough then it might be worth while.
I did not check prices recently, it can be a lot cheaper then about 2 years ago.


Microblocks. Build with logic.
 
plover

Guru

Joined: 18/04/2013
Location: Australia
Posts: 302
Posted: 03:31pm 20 Jun 2018
Copy link to clipboard 
Print this post

MicroBlocks
I had been pondering over have these could be mass produced without affecting cost. Even worse I was thinking about have this done within a circular hole.

It is out of the question for me with a high cost.

Thanks for the information though.
 
     Page 2 of 2    
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024