Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 15:23 25 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Other Stuff : Good Tips

     Page 2 of 2    
Author Message
norcold

Guru

Joined: 06/02/2011
Location: Australia
Posts: 670
Posted: 10:27pm 13 Sep 2012
Copy link to clipboard 
Print this post

Wind Turbine braking- On 3phase side use a 10 amp (or lower if you can get) 3phase circuit breaker, if will trip and put your turbine back under load(battery charging) before the current harms your windings.
We come from the land downunder.
Vic
 
Downwind

Guru

Joined: 09/09/2009
Location: Australia
Posts: 2333
Posted: 12:22am 14 Sep 2012
Copy link to clipboard 
Print this post

Norcold,

That sounds like a dangerous method to me, as you dump should be your controlling factor not your battery.
The thing saving your mill from a runaway should be your dump load and under no circumstances should you be unloading the mill to the battery because the dump current went up.

Sorry to say i think its a "Bad tip"

This would be better placed in the "Windmill" section and open for debate, rather than as a general tip.
Sometimes it just works
 
norcold

Guru

Joined: 06/02/2011
Location: Australia
Posts: 670
Posted: 08:04am 14 Sep 2012
Copy link to clipboard 
Print this post

To clarify talking about 500 watt turbines, drop in the ocean into 1000a/hr batteries in my case and I suspect in most 4m members case. With two of them at full output would hardly run the fridges. Works for me, has done for years. Sorry Downwind I`ll have to agree to disagree with you here. K.I.S.S
Edited by norcold 2012-09-15
We come from the land downunder.
Vic
 
Downwind

Guru

Joined: 09/09/2009
Location: Australia
Posts: 2333
Posted: 02:01am 15 Sep 2012
Copy link to clipboard 
Print this post

Norcold,

Lets just say its a method that suits your application and no what i would consider sound advice for a general windmill application on a broader scale.

I dont wish to discuss it further in this thread as a general tip because there is dedicated areas on this forum for such topics.

Pete.

Sometimes it just works
 
     Page 2 of 2    
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024