Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 08:52 26 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Windmills : 40A Auto to 100A Solenoid help.

     Page 2 of 2    
Author Message
domwild
Guru

Joined: 16/12/2005
Location: Australia
Posts: 873
Posted: 07:32pm 28 Aug 2012
Copy link to clipboard 
Print this post

To complete Downwind's schematic I am asking what I have forgotten here:

Add the following:

1. A brake across the 3-phase input from the mill
2. Fuse to load from battery
3. The suggested DC SS relay for dump load in preference to a relay with mechanical contacts

Through a Google search I also noticed a blocking diode should the mill feed into a common DC bus fed by other sources, e.g., generator, PV array, etc.

Thanks.

Taxation as a means of achieving prosperity is like a man standing inside a bucket trying to lift himself up.

Winston Churchill
 
     Page 2 of 2    
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024