Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 02:36 25 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : MM - can’t get USB working

     Page 2 of 2    
Author Message
bigmik

Guru

Joined: 20/06/2011
Location: Australia
Posts: 2914
Posted: 05:54am 15 Dec 2011
Copy link to clipboard 
Print this post

  BobD said   I just checked one of my laptops and it shows ports in use just like your machine. You're right. I think my machine is screwed.

Bob


Hmm, I think you mentioned you have previous backups of your system so make a current backup and try a clean install using the latest driver and nothing else... no virus scanners etc and see what happens..

Regards,

Mick
Mick's uMite Stuff can be found >>> HERE (Kindly hosted by Dontronics) <<<
 
BobD

Guru

Joined: 07/12/2011
Location: Australia
Posts: 935
Posted: 06:00am 15 Dec 2011
Copy link to clipboard 
Print this post

Mick
I think that will be the solution. I can't even think about it until I get back home next week and even then I'll have to get my head around the idea of doing a Windows install. If I do a minimal install and it works then I eventually have to do a full install. That is a non trivial task which is why I have good backups.

The final solution, if there is one, may be weeks away.

Bob
 
bigmik

Guru

Joined: 20/06/2011
Location: Australia
Posts: 2914
Posted: 06:04am 15 Dec 2011
Copy link to clipboard 
Print this post

  BobD said   Mick
I think that will be the solution. I can't even think about it until I get back home next week and even then I'll have to get my head around the idea of doing a Windows install. If I do a minimal install and it works then I eventually have to do a full install. That is a non trivial task which is why I have good backups.

The final solution, if there is one, may be weeks away.

Bob


I know, I posed it as a solution to see see if it is a hardware or a software fault...

If it works then it is software if it doesnt I would suggest something is screwy in your MB hardware,

regards,

Mick
Mick's uMite Stuff can be found >>> HERE (Kindly hosted by Dontronics) <<<
 
BobD

Guru

Joined: 07/12/2011
Location: Australia
Posts: 935
Posted: 04:25pm 15 Dec 2011
Copy link to clipboard 
Print this post

  bigmik said  
If it works then it is software if it doesnt I would suggest something is screwy in your MB hardware,



my bet is a software problem as the machine has both usb2 and usb3 which are implemented on different hardware and both fail.Edited by BobD 2011-12-17
 
     Page 2 of 2    
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024