Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 17:45 26 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Windmills : Broken Mill

     Page 2 of 2    
Author Message
JimBo911

Senior Member

Joined: 26/03/2009
Location: United States
Posts: 262
Posted: 02:32pm 20 Nov 2011
Copy link to clipboard 
Print this post

Karl

Yeah I learned a bunch. I cut out and welded up three 1/4 steel stiff backs that take the load off of the coupling. I then used them to attached the guy wires so far so good. My mill has now been flying about 9 months since the last time I lower the tower to do any adjustments. Shes been flying through some good storms and is still going strong. Of course now that I've said something, naaaa all is well.
Thanks
Jim
 
     Page 2 of 2    
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024