Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 23:05 22 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : Error accessing SD card

     Page 2 of 2    
Author Message
brucepython

Regular Member

Joined: 19/06/2011
Location: Australia
Posts: 64
Posted: 09:16pm 29 Jun 2011
Copy link to clipboard 
Print this post

Sandisk Ultra II, 2 Gb, SD works fine.
I also have a mystery one called "LX series" 16 Gb, SDHC, Class 10. It's fine too, though it could be a while before the Maxi collects that much data.
 
donmck

Guru

Joined: 09/06/2011
Location: Australia
Posts: 1313
Posted: 09:43pm 29 Jun 2011
Copy link to clipboard 
Print this post

  brucepython said   Sandisk Ultra II, 2 Gb, SD works fine.
I also have a mystery one called "LX series" 16 Gb, SDHC, Class 10. It's fine too, though it could be a while before the Maxi collects that much data.


Thanks Bruce, have also added:
http://www.themaximitecomputer.com/maximite-control/

Cheers Don...
https://www.dontronics.com
 
VK6MRG

Guru

Joined: 08/06/2011
Location: Australia
Posts: 347
Posted: 03:00am 30 Jun 2011
Copy link to clipboard 
Print this post

Maybe the problem with the SD cards is not the cards themselves but an issue with the Maximite. When I built the WIB, i had the same problems that some of you guys are having with the Maximite. It came down to the 3.3v regulator output voltage being slightly low. I changed the resister bias and to give me a voltage as close to 3.3v as possible. Some SD cards have a very fine voltage tolerance (window).
I just thought I'd share this experience with you in case it may help.
Its easier to ask forgiveness than to seek permission!

............VK6MRG.............VK3MGR............
 
donmck

Guru

Joined: 09/06/2011
Location: Australia
Posts: 1313
Posted: 04:10am 30 Jun 2011
Copy link to clipboard 
Print this post

  VK6MRG said   Maybe the problem with the SD cards is not the cards themselves but an issue with the Maximite. When I built the WIB, i had the same problems that some of you guys are having with the Maximite. It came down to the 3.3v regulator output voltage being slightly low. I changed the resister bias and to give me a voltage as close to 3.3v as possible. Some SD cards have a very fine voltage tolerance (window).
I just thought I'd share this experience with you in case it may help.


Good Lead, have added.

http://www.themaximitecomputer.com/maximite-control/

Cheers Don...
https://www.dontronics.com
 
     Page 2 of 2    
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024