 Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me. |
Forum Index : Windmills : Fibreglass windmill blades
  Page 2 of 2 |
|||||
| Author | Message | ||||
Gizmo Admin Group  Joined: 05/06/2004 Location: AustraliaPosts: 5078 |
Thats cause we're a bunch of Ozies.  The best time to plant a tree was twenty years ago, the second best time is right now. JAQ |
||||
| brucedownunder2 Guru  Joined: 14/09/2005 Location: AustraliaPosts: 1548 |
Hello Glenn and Trevor. I have a set of f/g blades from USA . They cost around $150 to land here, i then sanded and painted them . They come with small hub fittings which can be adapted to our spline by means of a 300mm disc, mine is 16mm weatherproof ply . They are 7 feet dia. A bit noisy,and require quite a blow to get them over 28v ,then they stall,lol. So, I'd recommend u's going to a bit larger indeed,. Say, min of 13 feet and the owners can cut a bit off later if they wish. Also make them rather wide at the root area to overcome the F&P cogging effect. Thanks, Bruce  Bushboy |
||||
kenputer Newbie  Joined: 02/05/2006 Location: CanadaPosts: 30 |
I have a set of art's blades also and am going to put them on my F&P but for now they are on a 200 volt PMDC motor and they seem to start up in very little wind. 
Ken As good as you are and as bad as I am,I'm as good as you are as bad as I am! |
||||
| Page 2 of 2 |
|||||
 Print this page |
