Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 02:45 28 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Electronics : PV Solar Water Heater From Modified 300W

     Page 2 of 2    
Author Message
hotwater
Senior Member

Joined: 29/08/2017
Location: United States
Posts: 120
Posted: 12:56pm 08 Apr 2019
Copy link to clipboard 
Print this post

This is the same thing a MPPT charge controller does. It charges a capacitor and pulses as much energy out as it can without going below the power point voltage. That charge time is usually in the fractions of seconds. When the battery is nearing full charge, the charging current drops. That raises the panel voltage and signals the heater control to start drawing power. Otherwise potential panel power is just wasted.
 
kanchana
Regular Member

Joined: 08/05/2018
Location: Sri Lanka
Posts: 56
Posted: 03:01pm 08 Apr 2019
Copy link to clipboard 
Print this post

Ok I understood now Thanks
Regards kanchana
 
     Page 2 of 2    
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024