Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 09:41 28 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Electronics : lm338 circuit voltage drop

     Page 2 of 2    
Author Message
Warpspeed
Guru

Joined: 09/08/2007
Location: Australia
Posts: 4406
Posted: 06:02pm 12 Sep 2018
Copy link to clipboard 
Print this post

Always best to read right through the application notes for the particular chip.

There are many of these three terminal regulators out there, and the internal circuitry does vary. Pay special attention to any capacitor requirements, some regulators will oscillate fairly readily if the input is not bypassed.

Protection diodes are also recommended if the output voltage can ever exceed the input voltage, which it sometimes can if there are very large capacitors on the output, or inductive loads such as motors.
Cheers,  Tony.
 
irishron40
Senior Member

Joined: 22/09/2014
Location: Ireland
Posts: 251
Posted: 10:52pm 14 Sep 2018
Copy link to clipboard 
Print this post

after so many frustrating times it was indeed cheap chinese transistor problem

Got some good ones from littlediodes in the uk

working all perfect now.

thanks everyone.
 
     Page 2 of 2    
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024