 Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me. |
Forum Index : Electronics : thermal transfer to copper board
| Author | Message | ||||
| flowerpetal Newbie  Joined: 26/08/2014 Location: AustraliaPosts: 5 |
for anyone who has had problems trying to tranfer their laserjet print from the thermal paper onto copper board ready for etching,throw away your irons and check out my youtube video https://www.youtube.com/watch?v=7PV99qNjvJ8&feature=youtu.be .I eventually came up with the idea after many a frustrating touch up and dodgy traces.I find the best etching method now is with copper chloride,as the video shows it works perfectly! |
||||
Downwind Guru  Joined: 09/09/2009 Location: AustraliaPosts: 2333 |
Best to use the hyper link button when you post a link to a differnt site. https://www.youtube.com/watch?v=7PV99qNjvJ8&feature=youtu.be Sometimes it just works |
||||
powerednut Senior Member  Joined: 09/12/2009 Location: AustraliaPosts: 221 |
Interesting method flower, thanks for posting. |
||||
| flowerpetal Newbie Joined: 26/08/2014 Location: AustraliaPosts: 5 |
Works a treat,don't worry about overheating as the cheapy heat guns don't get hot enough,better too much than not enough.The quality of paper helps too.One type of paper I have transfers the entire image leaving no trace on the paper whereas another one I have still leaves a faint image |
||||
 Print this page |
