TheBackShed.com

Home	JAQForum Ver 24.01
Log In or Join
Active Topics
Local Time 15:12 24 Nov 2024	Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Electronics : Induction motor advice

Author

Message

ozetrade

Regular Member

Joined: 15/10/2005
Location: Australia
Posts: 59

Posted: 12:43pm 07 Mar 2006

Copy link to clipboard

Print this post

I picked up this little 240v induction motor from the scrap yard and was wondering if it had potential. Keep in mind I'm only looking for 2amps plus @ 12v.

Output : 16.5/20w @200v-50/60Hz CAP 1.0/450

Identifying marks:
SUNG SHIN - KOREA
IC-9420G2KG7a
D.C.C Part No PMO01AG115
Seems to be a solid little beasty

If it has, what would be the best way to rebuild it - number/size/type of magnets to use on the armature etc. Wire size?

It has 24 poles wired with a very fine copper wire - which I'm prepared to rewire with a thicker wire - maybe .6mm or .8mm wire. The armature is quite small with a diameter of just 55mm, width 25mm. Shaft size is 10mm.

Any suggestions?

Greg
Just North of Brisbane in Redcliffe
OZeTrade.net

Print this page

To reply to this topic, you need to log in.