Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 17:40 28 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Electronics : Inverter input current waveform

Author Message
davef
Guru

Joined: 14/05/2006
Location: New Zealand
Posts: 499
Posted: 09:10am 22 Sep 2016
Copy link to clipboard 
Print this post

On my PowerMaster PM3000L 24V inverter with, for example, a 1kW resistive load the input current varies at a 100Hz rate and looks like a reasonable sinewave.

The current varies from quite a low value, say a few Amps up to 100A then back down to a few Amps over the 100Hz period. Average current about 50Amps and inverter efficiency about 90%.

There are quite a few inverter projects underway on the forum and I was hoping that people could tell me if what I see is common, or are there inverters that draw a steady DC current from the battery?

Thanks,
Dave
 
Madness

Guru

Joined: 08/10/2011
Location: Australia
Posts: 2498
Posted: 11:16am 22 Sep 2016
Copy link to clipboard 
Print this post

I am no expert but you see mentioned a lot "Ripple" which is what you are seeing, what capacitors does it have across the input?
There are only 10 types of people in the world: those who understand binary, and those who don't.
 
davef
Guru

Joined: 14/05/2006
Location: New Zealand
Posts: 499
Posted: 05:35pm 22 Sep 2016
Copy link to clipboard 
Print this post

No idea.

I have since been told that all inverters behave like this. The capacitance required to filter out the 100Hz would be very LARGE.
 
Tinker

Guru

Joined: 07/11/2007
Location: Australia
Posts: 1904
Posted: 11:36pm 22 Sep 2016
Copy link to clipboard 
Print this post

I'm curious. How did you measure (with what) that current?

BTW, the capacitors used in my inverter add up to 60,000uF/100V electrolytics.
Klaus
 
oztules

Guru

Joined: 26/07/2007
Location: Australia
Posts: 1686
Posted: 12:09am 23 Sep 2016
Copy link to clipboard 
Print this post

Yes what goes out must come in ......with a few losses.

At low power, the 60000uf I have will cover it pretty well, but as you get up to 2kw it is a significant flattened sine wave with the carrier impressed in it as well, and more pronounced as you climb up the scale.


..........oztules
Village idiot...or... just another hack out of his depth
 
davef
Guru

Joined: 14/05/2006
Location: New Zealand
Posts: 499
Posted: 08:04am 23 Sep 2016
Copy link to clipboard 
Print this post

Using at 90A 100mV shunt and a 'scope.

Thanks guys.
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024