Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 19:50 28 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Electronics : Hantek 6022 Logging

Author Message
Phil23
Guru

Joined: 27/03/2016
Location: Australia
Posts: 1664
Posted: 11:59am 03 Jun 2016
Copy link to clipboard 
Print this post

Hi All,
Just wondering about something regarding these scopes.
I would have thought if I set the horizontal rate to something like 10 Sec/Division I'd get a basic form of voltage Vs time to see if any occasional dips are occurring on a power rail.

Doesn't seem to be the case.

Is it my wrong interpretation of what should possible, or is this a limitation of the device & it's software.

What was in my mind was that at 200 Sec/Div I'd be able to see activity over an hour.

But even if I try say 10 Sec/Div, I don't get the trace I'd expect.


.

I would have expected a full screen trace after 100 seconds in the example above.

I know these aren't the greatest devices out there, but it's a cost/priorities thing.

Thanks

Phil

 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024