Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 21:49 28 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Electronics : rectifier connection to F&P

Author Message
Rubes
Newbie

Joined: 01/05/2009
Location:
Posts: 36
Posted: 08:11pm 10 Dec 2015
Copy link to clipboard 
Print this post

Hi Guys
I am sure this would have been covered somewhere but have searched in vain. Basically I need to know which of AC1, AC2 and AC3 of rectifier goes to which of the 3 wires from the rewired Fisher and Paykel genny.



Thanks in advance
 
Gizmo

Admin Group

Joined: 05/06/2004
Location: Australia
Posts: 5078
Posted: 10:47pm 10 Dec 2015
Copy link to clipboard 
Print this post

Hi Rubes

Doesn't matter, its 3 phase AC, and because we are converting it to DC, it does not matter which way you connect the 3 wires up. If you were wiring up a 3 phase motor, it would then be important, as the motor could run backwards if you get it wrong.

Glenn
The best time to plant a tree was twenty years ago, the second best time is right now.
JAQ
 
Rubes
Newbie

Joined: 01/05/2009
Location:
Posts: 36
Posted: 01:07pm 11 Dec 2015
Copy link to clipboard 
Print this post

Thanks Gizmo
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024