TheBackShed.com

Forum Index : Electronics : Recommend vero board drawing program

Author

Message

OA47

Guru

Joined: 11/04/2012
Location: Australia
Posts: 926

Posted: 05:02pm 23 Nov 2015

Copy link to clipboard

Print this post

Can some one recommend a free and simple vero /sea of holes drawing program. I would like to write up a simple project and would like to provide a vero type drawing for the component layout. ( it does have a mix of through hole and smd components)

GM

TassyJim

Guru

Joined: 07/08/2011
Location: Australia
Posts: 6101

Posted: 08:38pm 23 Nov 2015

Copy link to clipboard

Print this post

I used to use Veecad
http://veecad.com/

There is a free version available to play with.

Now I tend to use pen and paper but I must get back to using Veecad

Jim

VK7JH
MMedit MMBasic Help

OA47

Guru

Joined: 11/04/2012
Location: Australia
Posts: 926

Posted: 08:42pm 23 Nov 2015

Copy link to clipboard

Print this post

Thanks Jim, I will have a look at it.
GM

Pete Locke
Senior Member

Joined: 26/06/2013
Location: New Zealand
Posts: 181

Posted: 10:42pm 23 Nov 2015

Copy link to clipboard

Print this post

Many hair cuts back, when I used to have hair, I spent an afternoon hand drawing twice scale 0.15 matrix holes on an A3 sheet. Got that laminated and used a fine tip white board marker for vero board layups. Mind you, that was back in the days of ZX81 computers. No help in the tech world back then. Worked a treat, still do something similar these days. Low tech sometimes is the way to go. No batteries required

Downwind

Guru

Joined: 09/09/2009
Location: Australia
Posts: 2333

Posted: 03:01am 24 Nov 2015

Copy link to clipboard

Print this post

This is not quite "veroboard" but a "breadboard" layout tool, albeit rather basic.

http://www.picaxe.com/Software/Third-Party/PEBBLE/

I have checked it out but never used it, so no real comment on what you can do with it.

As for a good basic design package I use ExpressPCB as it can be used in the most simplest of way and includes through hole and SMD components, it also FREE.

Pete.Edited by Downwind 2015-11-25

Sometimes it just works

OA47

Guru

Joined: 11/04/2012
Location: Australia
Posts: 926

Posted: 06:19pm 24 Nov 2015

Copy link to clipboard

Print this post

Thanks Pete(s) I currently use Diptrace for my cct and pcb layouts (after many, many years of using the dos version of Protel ) and have seen some members of the forum displaying breadboard images with their projects and have just built and tested a project on sea of holes prototype board that I would like to write up. I could still use Diptrace to represent the boards.

GM

Print this page

To reply to this topic, you need to log in.