Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 02:39 29 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Electronics : resistor vallue

Author Message
irishron40
Senior Member

Joined: 22/09/2014
Location: Ireland
Posts: 251
Posted: 04:10pm 19 May 2015
Copy link to clipboard 
Print this post

Hello.

in this power supply it suggests R1 to be 2k2 2,5 Watt

http://electronics-diy.com/power-supply-lm317-2n3055-0-28v-6-8a.php

I dont have it, but I do have a 2k 5 watt cement resistor

would that be ok to use? or does it need to be 2k2

thank you

ron
 
BobD

Guru

Joined: 07/12/2011
Location: Australia
Posts: 935
Posted: 04:16pm 19 May 2015
Copy link to clipboard 
Print this post

Ron
That looks OK. It looks like it is there to drain the capacitor C2 when the power is shut off.
Bob
Edited by BobD 2015-05-21
 
Pete Locke
Senior Member

Joined: 26/06/2013
Location: New Zealand
Posts: 181
Posted: 11:04pm 19 May 2015
Copy link to clipboard 
Print this post

Bob is right. But given it's the low voltage side of the power supply you can leave it out. Just a discharge resistor. You could put anything above that ohm value to do the job. The wattage needed will decrease as the ohm value goes up. Simple equation is 'Watts (of resistor) = v squared over resistor value.
All good fun :-)
 
Pete Locke
Senior Member

Joined: 26/06/2013
Location: New Zealand
Posts: 181
Posted: 11:13pm 19 May 2015
Copy link to clipboard 
Print this post

This is a very good link to basic Ohms law...
http://commons.wikimedia.org/wiki/File:Ohm's_Law_Pie_chart.svg
 
irishron40
Senior Member

Joined: 22/09/2014
Location: Ireland
Posts: 251
Posted: 11:13pm 19 May 2015
Copy link to clipboard 
Print this post

so i could even put in a 20k 1/4 watt?


thanks

ron
 
BobD

Guru

Joined: 07/12/2011
Location: Australia
Posts: 935
Posted: 11:35pm 19 May 2015
Copy link to clipboard 
Print this post

Ron
Yes, you could. It all depends on how quick you want the stored electricity in the capacitors to bleed away.
Pete
I loved that diagram so much that here it is. I know the basics but to get the other I usually manipulate formulae. No need now.
Bob
2015-05-20_093343_OHMS_LAW.pdf
 
irishron40
Senior Member

Joined: 22/09/2014
Location: Ireland
Posts: 251
Posted: 12:12am 20 May 2015
Copy link to clipboard 
Print this post

thank you both.

ron
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024