TheBackShed.com

Home	JAQForum Ver 24.01
Log In or Join
Active Topics
Local Time 21:18 22 Nov 2024	Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Electronics : F&P_7 phase - connection

Author

Message

Gill

Senior Member

Joined: 11/11/2006
Location: Australia
Posts: 669

Posted: 09:18am 26 May 2007

Copy link to clipboard

Print this post

It was just after the release of the new motors that we all started looking at 7 phase, this being the least expensive way to utilise the new cogless feature.

We grasped the Star configuration quickly but Delta was somewhat elusive. I came up with the Inde (Independent)connection of running each phase to a bridge rectifier first then parallelling the outputs. This gives the same as Delta minus the losses from the extra diodes.

Well I just cracked the 7 Phase Delta configuration for those running two hubs or wanting to fit Star/Delta switches.

If poles are numbered 1 to 7, do not link 1 to 2, 2 to 3, 3 to 4 etc. as in 3 phase, Link1 to 3, 3 to 5, 5 to 7, 7 to 2, 2 to 4, 4 to 6, and 6 back to 1.

For those running the Independent configuration in Parallel (IndeP, aka open delta) to avoid harmonics, by connecting the bridges in series (IndeS) you get the same output as Star minus the extra diode loss.

So in summary, with 3 and 7 phase, we have Star and Delta switching before the rectifier giving minimal diode losses but prone to harmonic losses, and IndeS and IndeP switching after the rectifier with no harmonic losses but double the diode losses.

Don't you just love freedom of choice?Edited by Gill 2007-05-27

was working fine... til the smoke got out.
Cheers Gill _Cairns, FNQ

Highlander

Senior Member

Joined: 03/10/2006
Location: Australia
Posts: 266

Posted: 01:29am 27 May 2007

Copy link to clipboard

Print this post

Well done Gill

Can you do a rough wiring drawing and scan it?

Central Victorian highlands

Print this page

To reply to this topic, you need to log in.