Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 08:42 29 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Electronics : Welder to charger conversion

     Page 2 of 2    
Author Message
Warpspeed
Guru

Joined: 09/08/2007
Location: Australia
Posts: 4406
Posted: 02:31pm 11 Nov 2013
Copy link to clipboard 
Print this post

Less than ideal....
But another completely different way to go about all this is to scrounge an old car alternator and a suitably large electric motor, perhaps from a washing machine, or even a Briggs petrol engine.

Pretty ugly, but it is an ultra cheap and simple way to make a reliable high current voltage regulated 12 volt battery charger.


Cheers,  Tony.
 
     Page 2 of 2    
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024