 Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me. |
Forum Index : Electronics : 36v / 48v controller circuits
| Author | Message | ||||
| Willie Newbie  Joined: 03/04/2012 Location: South AfricaPosts: 2 |
Hi Down Under. I have built two 1.2 kw turbines but I battle with the electronics. Could anyone please help with circuits for 36v and 48v (simple) mill controllers, similar to the 12v controller on the site. I have no idea what should be changed to have the 12v work on the 36 and 48 v mills. Will appreciate any input. Thanks. Willie |
||||
Gizmo Admin Group  Joined: 05/06/2004 Location: AustraliaPosts: 5078 |
Hi Willie I get a few requests for this but I just dont have the spare time to look into it. You should be able to use any of the controller circuits on this site with a series regulator like Warpspeed posted on this page.... http://www.thebackshed.com/forum/forum_posts.asp?TID=4732&PN =2 But it will require some experimentation. Glenn The best time to plant a tree was twenty years ago, the second best time is right now. JAQ |
||||
| Willie Newbie Joined: 03/04/2012 Location: South AfricaPosts: 2 |
Hi Glenn Thanks for the advice, will try it out and let you know (what did not explode...!!) |
||||
 Print this page |
