Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 15:20 22 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Electronics : charging sealed lead acid batteries

Author Message
Hugh

Regular Member

Joined: 26/11/2006
Location: Canada
Posts: 41
Posted: 01:20am 09 Feb 2007
Copy link to clipboard 
Print this post

Hi there
Just acquired a dozen sealed lead acid batt., differnt manufacturers, however al stats are the same 12V 7Ah

charge instructions are
stand-by 13.5v-13.8v / Initial current no limit
cycle use 14.4v-14.7v / initial current 2.1A max.

can I use a charger thats rated @ 19v- 2.2amps
I'm willing to rectify the charger output, preferably without actually canceling its original use. I have a ongoing supply of these batt. and need to keep them topped up.
the charger is regulated & theres a 15 min quick charge built into the system and then it does the slow charge cycle, that eventually charges the 18v nicad in one hr.( the charger is a ryobi 18volt charger). That being said would it be possible to have them charge @ the same time.

I hope this makes a little bit of sense. Any help would be appreciated.
Hugh
thnxs allways
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024