Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 05:42 26 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Electronics : mosfet gate question

Author Message
Murphy's friend

Guru

Joined: 04/10/2019
Location: Australia
Posts: 648
Posted: 04:47am 04 Oct 2023
Copy link to clipboard 
Print this post

I want to connect two identical mosfets in parallel.

The usual way is to have a separate gate resistor to each gate from the driver output.

Is there a disadvantage when connecting the two gates together and have just a single gate resistor from the driver to that connection?
 
Solar Mike
Guru

Joined: 08/02/2015
Location: New Zealand
Posts: 1138
Posted: 07:55am 04 Oct 2023
Copy link to clipboard 
Print this post

  Murphy's friend said   ... Is there a disadvantage when connecting the two gates together and have just a single gate resistor from the driver to that connection?


Yes and depends, its not best practice to common them together driven via a single resistor. Individual Mosfets have an inherent input gate impedance that is different to some degree between batches; using individual gate resistors evens out any impedance mismatch.

For fast high power switching applications and you want current sharing, having a single common resistor means the mosfet with the lowest input impedance will hog the drive current and turn on first, it may blow up if it is not rated for the full current, while the others are yet to turn on; then they may cascade self destruct also.

For slow transition drive eg driven from a high Z current source, you can common the gates to a single resistor or leave it out.

Cheers
Mike
 
Murphy's friend

Guru

Joined: 04/10/2019
Location: Australia
Posts: 648
Posted: 09:48am 04 Oct 2023
Copy link to clipboard 
Print this post

Thanks Mike, I won't risk it then. Its for that SMD mosfet inverter I'm building.
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024