Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 20:40 27 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Electronics : Another Saturation Tester Design

     Page 2 of 2    
Author Message
Warpspeed
Guru

Joined: 09/08/2007
Location: Australia
Posts: 4406
Posted: 12:14am 17 Jun 2019
Copy link to clipboard 
Print this post

  nickskethisniks said  
I want to test an inductor for a buck converter.

First establish your choke requirements, and there are three main issues.

The absolute maximum dc current, which is straightforward.

The required inductance, which sets the ripple current which will always be at maximum at 50% duty cycle, and reduces to zero at both 100% and 0% duty cycle.
Consider how the peak to peak ripple current may force a buck converter go discontinuous at very light loading.

Thirdly, core loss, which is not usually a problem with chokes, but can be if you use an unsuitable material at both very high voltage swing, and high frequency, with far too few turns.

Its exactly like designing a transformer, you need both enough turns, and enough core cross sectional area to prevent ac magnetic saturation, and its the applied ac voltage that does that.
Dc ampere turns are a very different thing, and its the dc plus ac flux that gets you up to saturation. So if you use sufficient turns core loss usually becomes very low in a choke and can often just be ignored.

Anyhow, once you have established a max required dc current and required inductance, you can then turn to your inductor tester for some results.

The test conditions such as voltage, frequency, and duty cycle make no difference at all. If your choke measurement produces figures of xx microhenries and saturates at yy amps, that is what it is.

It may run under vastly different conditions in your buck regulator, but that choke will still have xx inductance, and saturate at yy current, which is all you really need to be sure of.

So no need to try and duplicate the running conditions in the actual buck regulator.
Just wind up the wick on your tester to get some nice results, and job done.
Cheers,  Tony.
 
Warpspeed
Guru

Joined: 09/08/2007
Location: Australia
Posts: 4406
Posted: 12:21am 17 Jun 2019
Copy link to clipboard 
Print this post

Very nice find there Poida
I knew it was out there somewhere.

That Billings book is an excellent read, and especially good for magnetics.
Cheers,  Tony.
 
     Page 2 of 2    
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024