 Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me. |
Forum Index : Windmills : Wind Turbines
| Author | Message | ||||
| glen Newbie  Joined: 09/01/2013 Location: AustraliaPosts: 1 |
As a new member to a Forum I am not sure what I am doing. I have a Vertical axis wind turbine in my shed which is taking up room. I would have liked to finished it but since my electronic minded brother has passed away I have lost interest and was hopeing someone else close by would be interested in carrying on with the project. If anyone is interested contact me please.Wind Turbines I have tried to download a picture of it but it didn't hapen so if you are interested I should be able to email it to you thank you. f |
||||
wallablack Senior Member  Joined: 10/08/2011 Location: AustraliaPosts: 164 |
Welcome Glen, Very sad to hear about your brother. There is a wealth of information available here and some very helpful members. Depending on what stage you are at you could pick up where you left off as the electrics of these is not too tricky if you research a bit and follow the information from experienced members... It would be nice to see her finished and read your story. Where are you located? Foolproof systems do not take into account the ingenuity of fools. |
||||
 Print this page |
