Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 22:36 27 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Windmills : FANUC SERVO MOTOR HELP NEEDED

Author Message
isaiah

Guru

Joined: 25/12/2009
Location: United States
Posts: 303
Posted: 02:50am 15 Aug 2010
Copy link to clipboard 
Print this post

Bub's has a fanuc servo motor with a tapered shaft and wants me to turn it straight!
can this be done by taking the armature out of the motor and put it ni the lathe and turn a section of the shaft straight to fit a hub for wind mill blades without the magnets going dead??
I understand if you were to take the armature and turn it at hi rpm's in the lathe the magnets may become dislocated.
Dose any one have any input on this ?
Dose anybody know what thread and pitch is on the shaft it looks to be 12 mm something fine?
any help will be appreciated.
URL=http://www.motherearthnews.com/Renewable-Energy/1973-11- 01/The-Plowboy-Interview.aspx>The Plowboy Interview[/URL>
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024