Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 19:27 23 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Windmills : Programming PIC MX250

Author Message
palcal

Guru

Joined: 12/10/2011
Location: Australia
Posts: 1873
Posted: 10:19pm 03 Oct 2024
Copy link to clipboard 
Print this post

I have always had trouble using my PicKit3 programmer getting it to connect. I bought an MPLAB Snap but when I try to connect I get the message
"You have entered an invalid value (null) for the Voltage Level on the Snap Power property page." Wherever that is.No idea what that means.
I don't think this would work but for the MX170s I program them in circuit via the 1455 using the PicProg gui. If I put the MX250 in a 170 board will it program.
"It is better to be ignorant and ask a stupid question than to be plain Stupid and not ask at all"
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024