TheBackShed.com

Home	JAQForum Ver 24.01
Log In or Join
Active Topics
Local Time 13:22 25 Nov 2024	Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Windmills : 3 phase turbine testing

Author

Message

Jules
Newbie

Joined: 08/05/2014
Location: Australia
Posts: 9

Posted: 04:55pm 20 Mar 2015

Copy link to clipboard

Print this post

Can anyone tell me how to test a 3 phase turbine for a dead short?

I unfortunately managed to jam one of my connections in the tower hinge last time i raised the turbine, took 3 months to break down but I'm assume one of the windings has burnt out any ideas people?

VK4AYQ
Guru

Joined: 02/12/2009
Location: Australia
Posts: 2539

Posted: 09:20pm 20 Mar 2015

Copy link to clipboard

Print this post

Hi Jules

Some more details needed.

Is the turbine star or delta connected

Do you have it down, what voltage is it, is there any shorts to earth on the down phase.

Is the wiring to the turbine intact, is the restifier still working on all phases.

Are the rotator brushes intact

Have you done voltage checks have you done low ohms check.

All the best

Bob

Foolin Around

Print this page

To reply to this topic, you need to log in.