Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 12:14 25 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Windmills : Soma wind generator disassembly

Author Message
gactrx
Newbie

Joined: 09/02/2015
Location: New Zealand
Posts: 4
Posted: 08:56am 09 Mar 2015
Copy link to clipboard 
Print this post

Hi, has anyone pulled the slipring out of one of these? I have removed the but when trying to lever out the sliprings and bearings with two levers between the square section housing and the rotating pipe sleeve it doesn't move. Do the sliprings pass though the bearing ok?
Thanks,
 
gactrx
Newbie

Joined: 09/02/2015
Location: New Zealand
Posts: 4
Posted: 04:19pm 23 Aug 2015
Copy link to clipboard 
Print this post

When replacing the swivel pole bearings unsolder and remove the slip ring cables first. Pull the cables out from the hollow shaft. Then press bearing including slip ring assembly off.
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024