Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 13:52 25 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Windmills : motenergy me1016 pm generator

Author Message
trout
Newbie

Joined: 29/11/2014
Location: Australia
Posts: 24
Posted: 10:35pm 03 Feb 2015
Copy link to clipboard 
Print this post

Hi there is this a quality hydro generator?????
 
davef
Guru

Joined: 14/05/2006
Location: New Zealand
Posts: 499
Posted: 11:42pm 03 Feb 2015
Copy link to clipboard 
Print this post

Two things that concern me. Small generators run at about 50%, so at 3KW you will need a good airflow to keep it cool. The other thing is that it looks quite narrow, does it have two bearings on the shaft?

Especially with a single jet I would imagine there are quite large out-of-balance forces on the shaft.

Maybe ask on otherpower.com

What power levels do you think you will be operating at?Edited by davef 2015-02-05
 
davef
Guru

Joined: 14/05/2006
Location: New Zealand
Posts: 499
Posted: 11:54pm 03 Feb 2015
Copy link to clipboard 
Print this post

Another issue is 1KW at 12Volts is a lot of current. Are you planning to put your batteries within a few metres of the generator?
 
trout
Newbie

Joined: 29/11/2014
Location: Australia
Posts: 24
Posted: 11:42pm 04 Feb 2015
Copy link to clipboard 
Print this post

Hi dave the overheating should be kept under control by the ceramic magnets, not sure about the 1 or 2 bearing thang
 
Downwind

Guru

Joined: 09/09/2009
Location: Australia
Posts: 2333
Posted: 12:46am 05 Feb 2015
Copy link to clipboard 
Print this post

So what is the temp range of the magnets??

As all magnets loose power with temperature.

I think your view is a little flawed, or perhaps wishful thinking.

Pete.
Sometimes it just works
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024