Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 12:01 25 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Windmills : f&p hydro power

Author Message
trout
Newbie

Joined: 29/11/2014
Location: Australia
Posts: 24
Posted: 02:00pm 12 Dec 2014
Copy link to clipboard 
Print this post

Hi yas does anyone know the minimum rpm that I would need to produce on my fisher paycal smart drive to get 12 volt power to charge my battery? Cheers
 
davef
Guru

Joined: 14/05/2006
Location: New Zealand
Posts: 499
Posted: 02:35pm 12 Dec 2014
Copy link to clipboard 
Print this post

You tell me which F&P motor you have and I'll tell you how much power you will get versus RPM.
 
trout
Newbie

Joined: 29/11/2014
Location: Australia
Posts: 24
Posted: 01:26pm 13 Dec 2014
Copy link to clipboard 
Print this post

Hi there I have the 36 finger one
 
Jarbar
Senior Member

Joined: 03/02/2008
Location: Australia
Posts: 224
Posted: 02:40pm 13 Dec 2014
Copy link to clipboard 
Print this post

You'll also need to measure the wire diameter.
"Creativity is detirmined by the way you hold your tounge".My Father
"Your generation will have to correct the problems made by mine".My Grandfather.
 
Pete Locke
Senior Member

Joined: 26/06/2013
Location: New Zealand
Posts: 181
Posted: 11:54pm 13 Dec 2014
Copy link to clipboard 
Print this post

http://www.thebackshed.com/forum/forum_posts.asp?TID=5853

http://www.thebackshed.com/forum/forum_posts.asp?TID=5994

This is what I did for a water wheel set up for a mate of mine. Might be something you can use .
 
trout
Newbie

Joined: 29/11/2014
Location: Australia
Posts: 24
Posted: 03:02pm 14 Dec 2014
Copy link to clipboard 
Print this post

0.6mm wire
 
davef
Guru

Joined: 14/05/2006
Location: New Zealand
Posts: 499
Posted: 10:17pm 14 Dec 2014
Copy link to clipboard 
Print this post

I have PM'ed you.
 
derekos
Newbie

Joined: 27/06/2015
Location: Australia
Posts: 3
Posted: 02:53pm 27 Jun 2015
Copy link to clipboard 
Print this post

hello everyone. can you tell me how to attach two F & P motors to one shaft.Is this something I can do myself or do I have to take it to a machine shop?
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024