Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 01:20 26 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Windmills : Wind Turbine Solar Inverter

     Page 2 of 2    
Author Message
norcold

Guru

Joined: 06/02/2011
Location: Australia
Posts: 670
Posted: 01:00pm 04 Jan 2013
Copy link to clipboard 
Print this post

I`ll add my collection of antique spirit level bubbles that Yahoo2`s on the money. If that 10mm is 10mm diameter I`ll relieve you of them for all my bubbles
We come from the land downunder.
Vic
 
MOBI
Guru

Joined: 02/12/2012
Location: Australia
Posts: 819
Posted: 01:16pm 04 Jan 2013
Copy link to clipboard 
Print this post

  norcold said  Your current wiring may be enough, would depend on the number of panels wired in seies. My system has 3 banks (arrays) of 6 X 12v panels. Which equates to up to 120 volts per array max(6X20v) Cells are poly also. Wiring is only 4mm which is ample as time has proved.


The sun was shining brightly this morning at 0800 and the system was charging at 26+ amps.

My array is 2 banks of BP Solar 85watt poly silicon panels. Each bank is 4 x 12v in parallel. The two banks are then in series to give me a 24v system.

My solar voltage usually sits around 40v on a sunny day such as today. I probably don't need heavier wire than I have, but the set up isn't the neatest in the panel wiring department so when I tidy it up (counduit etc) I'll put in the 10mm cable.

I might see if I can set up a logger to record things such as solar volts over a period of time to cover days from sunny to overcast.

I reckon we need a topic just called "My System" or something similar to showcase what we each have - a bit like a blog.

  yahoo2 said  I would be doing the boring stuff first.

Get the multimeter out and probe the back of the panels and see what potential you have to work with.


That's on my list of things to do. I want to get the new array mounted on the shed roof and then I'll do the tidy up and overhaul thing.

Edited by MOBI 2013-01-05
David M.
 
     Page 2 of 2    
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024