Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 13:34 26 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Windmills : blade extenders

Author Message
Bub73

Senior Member

Joined: 10/12/2009
Location: United States
Posts: 116
Posted: 09:43pm 25 Dec 2011
Copy link to clipboard 
Print this post

Below are some blade extender's I made up to make a 6'sweep blade out of a 4' blade.
They seem to be working with the wind we have at present.
The extender is made of Aluminum 1''x1/4 '' x 16''


Below are two pictures of the mill running at night with the deicer's on.




We don't have a data logger on this mill to record the increase but the dump load has been tripped more than we ever seen it before a 12 volt system.
Isaiah on Bubs Computer
Enjoy the Holiday Season

 
VK4AYQ
Guru

Joined: 02/12/2009
Location: Australia
Posts: 2539
Posted: 10:28pm 25 Dec 2011
Copy link to clipboard 
Print this post

Hi Isaiah

The dump loads tell the real story,

All the best

Bob
Foolin Around
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024