Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 23:38 24 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Windmills : A REALLY simple blade design!

Author Message
KiwiJohn
Guru

Joined: 01/12/2005
Location: New Zealand
Posts: 691
Posted: 07:53pm 05 Jan 2007
Copy link to clipboard 
Print this post

I thought of this while driving to work the other day! I tried the idea with a sheet of paper and it does appear to have potential!

This is for a very simple sheet metal blade with a twist and an "airfoil" section.

To get the idea just take a sheet of writing paper and fold it exactly longways down the centre. Now pick it up holding the folded corners together. Depending on how heavily you made the crease you will have a symetrical section airfoil shape. Now slide two corners away from their mates just a little and watch how the sheet takes on a twisted airfoil shape.

Making a matched set from sheet metal might be a challenge but I think it could be done if some sort of wooden (?) jig was made up. A shaped piece of wood set in resin at one end would give something to attach to the hub.

No doubt the sheet could be trimmed somewhat to gave a shaped blade.

Just an idea someone might like to play with.
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024