TheBackShed.com

Home	JAQForum Ver 24.01
Log In or Join
Active Topics
Local Time 05:53 26 Nov 2024	Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Windmills : Vawt...going in a big way

Page 16 of 16

Author

Message

mac46

Guru

Joined: 07/02/2008
Location: United States
Posts: 412

Posted: 04:17pm 08 Dec 2011

Copy link to clipboard

Print this post

Hello Greenbelt,

Thank you for posting this, "Basic Inductance" , I've read through it a few times now and need to study it more to grasp the debth of information contained.
Regards,

Mac46

I'm just a farmer

mac46

Guru

Joined: 07/02/2008
Location: United States
Posts: 412

Posted: 02:41pm 25 Jul 2012

Copy link to clipboard

Print this post

Everyone,
I can not say that I have made progress yet or not. I have been trying differant things with the mill. it's sort of like "you have to know how to fly", to be able to get this thing to work like I think it should...if that helps describe things better.
Right now I have a 12 volt starter motor that I use to spin the thing up to speed and then it runs ok on its own, I'm thinking of changeing over to a 2 hp 240 volt motor and maybe useing it to charge things once its up to speed.
The big thing (or problem) is getting the mill up to speed and then back down to zero rpm after I am finished as I have a low speed "wobble" in the main rotor. its really hard on the disc break. I don't run this thing every day, just when I know that I will be around to keep an eye on it.

Mac46

I'm just a farmer

Page 16 of 16

Print this page

To reply to this topic, you need to log in.