Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 08:22 27 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Windmills : Power regulator HELP !!!! PLEASE

Author Message
redbullalan

Newbie

Joined: 17/01/2011
Location: United Kingdom
Posts: 38
Posted: 09:32pm 11 Feb 2011
Copy link to clipboard 
Print this post



Hi still cannot get my head round this one been looking for an age can you help.

At the moment running a small mill to chard batteries still waiting on a mate to build my charge controller so manually monitoring the bats.

What i don’t know and concerns me is the mill can get up to 30-35 v with no lode.

Do i need to regulate the power going into the batteries seen a few things saying the battery will clamp the power is this correct or will it blow the batteries up.

Do i need to regulate the power going in if so how.

Thanks for your time

Alan

hope to have a charge controler soon

Reddbull alan
 
VK4AYQ
Guru

Joined: 02/12/2009
Location: Australia
Posts: 2539
Posted: 11:28pm 11 Feb 2011
Copy link to clipboard 
Print this post

Hi Allan

The voltage you are getting will be OK for 24 volt system as the batteries will load the voltage down, it is the amps at that charge voltage that could do the damage, generally if the charge amps goes over five percent of the battery total amp hour at full charge it can cause problems. eg: 5 amps on a 100 amp hour battery bank.

The simple way is to make a dump load controller as Glenn has designed. It is in the electronic section from the front page, it is so simple even I can make it.

All the best

Bob
Foolin Around
 
redbullalan

Newbie

Joined: 17/01/2011
Location: United Kingdom
Posts: 38
Posted: 11:03am 13 Feb 2011
Copy link to clipboard 
Print this post


Hi
Working on a 12 v setup very concernd im going to put to higher voltage into the batteries im thinking if I use the bits out of an alternator may regulate it down until I get my charge controller built
Reddbull alan
 
redbullalan

Newbie

Joined: 17/01/2011
Location: United Kingdom
Posts: 38
Posted: 11:05am 13 Feb 2011
Copy link to clipboard 
Print this post


Reddbull alan
 
itsandbits1
Regular Member

Joined: 13/08/2010
Location: Canada
Posts: 81
Posted: 04:58pm 13 Feb 2011
Copy link to clipboard 
Print this post

the bits out of the alt; voltage regulator, don't work the right way.
the alt parts monitor the batt voltage allright, but what they do is put current into the exciter coil of the alt; depending on the voltage monitored, and turn the rotor magnet to various strengths so the alt output goes up and down.
You could use the regulator to turn a switch on and off useing a relay to turn the system to dump or charge circuit but I think a physical switch like this will chatter and arc, maybe a cap across the coil leads will help
 
redbullalan

Newbie

Joined: 17/01/2011
Location: United Kingdom
Posts: 38
Posted: 08:08pm 13 Feb 2011
Copy link to clipboard 
Print this post


Thanks for the info its will have to re think till i get the charge controller.
Parts of this are still a bit black magic to me but i will have to learn
Reddbull alan
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024