Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 01:48 26 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Windmills : PicLog finally updated, Ver 1.2

     Page 2 of 2    
Author Message
Gizmo

Admin Group

Joined: 05/06/2004
Location: Australia
Posts: 5078
Posted: 10:17am 26 Feb 2013
Copy link to clipboard 
Print this post

I'll look into the 28X2 to see if it should work. Just a bit tied up at the moment, give me a couple of days.

The PIC16F873A wont work, its not programmed with the PicAxe boot loader.

Glenn
The best time to plant a tree was twenty years ago, the second best time is right now.
JAQ
 
scnarine
Newbie

Joined: 17/06/2011
Location: United States
Posts: 29
Posted: 09:11am 27 Feb 2013
Copy link to clipboard 
Print this post

Hello Glen,
I was able to program a PICAXE-28X1 (PIC16F886) successfully with your version 1 code. In order to use the PICAXE-28X2 (PIC18F25K22) I use the PICAXE wizard in the programming editor to X2 conversion. I do have a problem with the nap command (syntax errors). If I change the nap command to doze I was able to program X2 chip, but I am unsure about the duration of the doze, since for example nap 7 seems to be shorter than doze 7 and I am not sure if doze will be the correct command. Version 2 code you must make sure the LCD is a 20x2 and not a 16x2 as the schematic shows. I missed that point although it was mention on the web page :).

Thanks again Glen.
Sudesh
 
scnarine
Newbie

Joined: 17/06/2011
Location: United States
Posts: 29
Posted: 05:24pm 20 Mar 2013
Copy link to clipboard 
Print this post

I now have a 20x2 LCD but cant get the version 2 code to work on the chip. Version 1 works fine. I am unable to find the PICAXE-28X chip anywhere. Is there a possibility that some one can dump their picaxe chip with the version 2 code and I can try writing that hex code to my PIC16F873A chip and see if that will work? or someone with a revolution programmer convert the version 2 code using the wizard in the program editor. Please help me.

Thank you.
Sudesh
 
     Page 2 of 2    
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024