 Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me. |
Forum Index : Windmills : Horwood Bagshaw/Metters
| Author | Message | ||||
| jack Newbie  Joined: 18/12/2022 Location: AustraliaPosts: 2 |
Hello, is there someone who knows about old windmills/old windpumps. I have a Horwood Bagshaw/Metters over a bore and the pump rod that extends out of the bottom of the gearbox is worn nearly through from scraping on the side of the gearbox casing. I have spare steel rods and so I need to know the type and size of the thread at either end of the pump rod, for instance: 7/16 or 1/2 inch, and whitworth or bsf etc. thanks. |
||||
Revlac Guru  Joined: 31/12/2016 Location: AustraliaPosts: 1022 |
Not sure this is of any help. I measured 2 pumps, and the pull rod nuts are different, one is 5/8 18 UNF and the other 5/8 11 UNC ones for sale are mostly 5/8 BSW They might be southern cross, I do have a windmill in parts but it is a different brand, the others are Jack pumps similar to those in the document pg 58. onwards. http://www.gvps.com.au/Tech_specs/Windmills/Metters%20Mills%20Pumps%20Pumping%20Gears%20Troughing%20Squatters%20Tanks%20Tank%20Stands%20Etc%201944.pdf Cheers Aaron Off The Grid |
||||
| jack Newbie Joined: 18/12/2022 Location: AustraliaPosts: 2 |
Thanks Aaron that's helpful, and good .pdf document. |
||||
 Print this page |
