 Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me. |
Forum Index : Windmills : Motor Winding Wire Gauge Sizing as per Good rule of Thumb Approach
| Author | Message | ||||
| Kamak Senior Member  Joined: 13/04/2021 Location: CanadaPosts: 150 |
Use 300-400 CMA (Circular Mil Area) per Amp. I don't fully understand why this value of CMA is used as a guideline, but I will lend my trust to the people that know and start by accepting this rule of thumb. As it is, it even seems to be a bit of a conservative rule, as I have read some comments about it, suggesting even greater liberal use of wire gauge per Amp. CMA is a simple calculation: https://en.wikipedia.org/wiki/Circular_mil Wire Dia^2 or Dia x Dia https://www.eng-tips.com/viewthread.cfm?qid=290662 http://www.zierick.com/pdf/wire.pdf  Edited 2021-04-22 09:03 by Kamak |
||||
 Print this page |
