TheBackShed.com

Home	JAQForum Ver 24.01
Log In or Join
Active Topics
Local Time 11:33 05 Dec 2024	Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : PCB Manufacturing : panelising

Author

Message

isochronic
Guru

Joined: 21/01/2012
Location: Australia
Posts: 689

Posted: 08:49pm 24 Sep 2016

Copy link to clipboard

Print this post

When panelising, can all the panel area be used, or is some space needed for
handling etc ?
(ed) eg the 10cm square standard size is cheap , can it be split into 4 x 5x5
or 2 x 10x5 parts ?
Edited by chronic 2016-09-26

Grogster

Admin Group

Joined: 31/12/2012
Location: New Zealand
Posts: 9311

Posted: 04:30pm 25 Sep 2016

Copy link to clipboard

Print this post

You can split it into the sizes you state, but you are absolutely correct - you need to leave a little room around the edge for the V-grooving:

In the above image, note that the OUTLINE layer defines the four separate boards on the 100x100 panel, with the dividing lines being at 50mm horizontal and 50mm vertical.

The boards themselves though CANNOT be EXACTLY 50mm square, you need to design them to be at least 1mm narrower to allow room for the V-groove.

In the example above, each of those boards is actually 49mm x 49mm rather then 50 x 50 if you see what I am getting at.

Done like that, you can snap the boards out of the V-groove panel, and they will always be perfect.

Smoke makes things work. When the smoke gets out, it stops!

Print this page

To reply to this topic, you need to log in.