 Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me. |
Forum Index : PCB Manufacturing : Trouble loading .net 4
| Author | Message | ||||
| smudge Newbie  Joined: 04/12/2014 Location: United KingdomPosts: 16 |
Hi I've bought Autotrax and I've loaded in into Windows 7 (64). It's a genuine registered copy and is running under bootcamp on a Mac. When it asks for .net i download it successfully then it just sits there trying to instal and gets no further. Anyone else had this problem and found a solution? Thanks Smudge |
||||
belsean21 Newbie Joined: 06/07/2013 Location: AustraliaPosts: 12 |
Not familiar with Macs or bootcamp. However, this may help. Unified .NET Framework Troubleshooting Guide Updated: what to do if other .NET Framework setup troubleshooting steps do not help Try the Microsoft .NET Framework Repair Tool If that doesn't work you may need to use the .NET Framework Cleanup Tool & reinstall .NET from scratch .NET Framework Cleanup Tool User’s Guide Sean. |
||||
bigmik Guru  Joined: 20/06/2011 Location: AustraliaPosts: 2916 |
Hi Smudge, As I dont have any MACs to play around with I cannot help directly. Have you tried the AutoTRAX forum http://www.forum.kov.com/ If you are not a member PM me with an email address and I can send you an invite.. You should get a response to your problem, usually within 24hrs. I am sure someone else has had the same problem as you. Kind Regards, Mick Mick's uMite Stuff can be found >>> HERE (Kindly hosted by Dontronics) <<< |
||||
 Print this page |
