Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 19:36 24 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : (DM) Poor man’s DuinoMite Mega Enclosure.

Author Message
DuinoMiteMegaAn
Senior Member

Joined: 17/11/2011
Location: Australia
Posts: 231
Posted: 05:08pm 27 Nov 2011
Copy link to clipboard 
Print this post

(DM) Poor man's DuinoMite Mega Enclosure.

Until the Olimex milled box arrives in stock this is a low cost alternative box that just fits the DuinoMite Mega.

I found this anti-static 3.5" hard drive disk box that just fits the DuinoMite Mega.
You need to use a rotary tool (Dremel or compatible) to cut the sides out for the I/O connectors. Hackers - precision plastic machining required.

Link: http://www.9mart.com/products/2-Pieces-of-Anti%252dStatic-Pr otectors-Cases-Box-For-3.5%22-IDE-SATA-HDD.html
Link: http://www.amazon.com/3-5-Hard-Drive-Protection-BLACK/dp/B00 57R18NYEdited by DuinoMiteMegaAn 2011-11-29
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024