 Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me. |
Forum Index : Microcontroller and PC projects : UBW32 Interface Boards
| Author | Message | ||||
Dinosaur Guru  Joined: 12/08/2011 Location: AustraliaPosts: 311 |
Hi All I have used the ubw32 for a few years now, and have manufactured a few boards to interface to it. These are all used on industrial weighing machines. I even got the usa to write some code to implement a phase angle firing program with eight outputs. However, I have now "retired" and some old customers are interested in replacing my boards with "off the shelf" boards. I am looking for a 24 vdc input board, and an output board for opto relays. Typically no more then 4 inputs and 8 outputs. I have seen some boards on this forum, but not sure how long these will be available. Searching on the web for "UBW32 Interface boards" proved fruitless, so I am hoping some of you guys have sourced or implemented Arduino boards for this purpose. Any suggestions ? Regards Regards Hervey Bay Qld. |
||||
donmck Guru Joined: 09/06/2011 Location: AustraliaPosts: 1313 |
Don't know if this will help: I have boards that I post out as an Air Mail letter. You can just populate with what you need. Two boards, but it will get you from the UBW32 to an Arduino shield. this will get from UBW32 to a 26 pin header. http://www.dontronics-shop.com/ubw32-mcc-pcb-letter.html This will get you from the 26 pin header to an Arduino footprint. http://www.dontronics-shop.com/donduino-cross-letter.html As I say, it may or may not assist, but if you don't know, it definitely can't help you. :-) Don... https://www.dontronics.com |
||||
 Print this page |
