Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 01:51 28 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : MM-BMP085

Author Message
palcal

Guru

Joined: 12/10/2011
Location: Australia
Posts: 1873
Posted: 06:48pm 03 Jul 2013
Copy link to clipboard 
Print this post

I'm trying to read the values from the BMP085 temperature/pressure sensor. I am using the code posted by Olimex from Feb 2012 for the Duinomite. All I get is error messages. The sensor behaves as if it is not connected.
Does the code need changing to run on the MM.
Palcal.Edited by palcal 2013-07-05
"It is better to be ignorant and ask a stupid question than to be plain Stupid and not ask at all"
 
palcal

Guru

Joined: 12/10/2011
Location: Australia
Posts: 1873
Posted: 07:02pm 03 Jul 2013
Copy link to clipboard 
Print this post

Forget it. It helps to connect the pull up resistors.
"It is better to be ignorant and ask a stupid question than to be plain Stupid and not ask at all"
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024