 Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me. |
Forum Index : Microcontroller and PC projects : MM doesn’t show in Device manager WinXP
| Author | Message | ||||
BobDevries Senior Member  Joined: 08/06/2011 Location: AustraliaPosts: 266 |
Hello all, I just upgraded to MMBasic 4.4B1. I don't know if it's a result of the upgrade, but the MM (original mono) no longer shows up as a serial port in Device manager. It works fine when plugged into a monitor. Any one know what could cause this behaviour? It did work before. Regards, Bob Devries Dalby, QLD, Australia |
||||
| BobDevries Senior Member Joined: 08/06/2011 Location: AustraliaPosts: 266 |
Further details... I usually plug the MM into the PC via a USB hub. If I plug it in directly to a USB port on the computer, it works fine, but not on the hub. Comments? Bob Devries Dalby, QLD, Australia |
||||
James_From_Canb Senior Member Joined: 19/06/2011 Location: AustraliaPosts: 265 |
Bob, That sounds similar to a problem I had earlier in the year. Try clearing unused com port allocations by the method TZ found. It's in thread Tbs link James My mind is aglow with whirling, transient nodes of thought careening through a cosmic vapor of invention. Hedley Lamarr, Blazing Saddles (1974) |
||||
 Print this page |
