Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 17:31 27 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : Pickit 3 programmer

Author Message
vk4tec

Senior Member

Joined: 24/03/2012
Location: Australia
Posts: 239
Posted: 08:48pm 18 May 2013
Copy link to clipboard 
Print this post

Guys

I am guessing a pickit 3 programmer will do ICSP

I just need to map the programming pins to my PIC

16F628 16F877

Andrew
Andrew Rich VK4TEC
www.tech-software.net
 
MOBI
Guru

Joined: 02/12/2012
Location: Australia
Posts: 819
Posted: 01:46pm 19 May 2013
Copy link to clipboard 
Print this post

  Quote  I am guessing a pickit 3 programmer will do ICSP


Sure! I use it to programme blank PIC32s for the MM.

Do you have a pickit3?

Just connect the pins of the pickit3 to the pins on the pic with the same name and using MPLAB IDE or IPE should be a cinch.

You will probably need a 10K resistor from MCLR to +5v

If you need further info, just yell.
David M.
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024