 Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me. |
Forum Index : Microcontroller and PC projects : CMM: help needed
| Author | Message | ||||
Juri74 Senior Member  Joined: 06/02/2012 Location: ItalyPosts: 162 |
hello all.. i'm experiencing troubles with file management with color maximite / ubw32 i do not know if it's a bug or if my ubw32 have problems so i'll post a test program here asking some help, try it and let me know if your maximite will reboot without any reasons.. i attach a zip file containing the test.bas file and a jpg file called "fridge.jpg" all you have to do is to run the test program, give for input file the "fridge.jpg" and any name for output file.. you can use any other files but i encouter that fault with files bigger than 2kb Input "infile";a$
Input "outfile";b$ Open a$ For input As 1:Open b$ For output As 2 x=0 Do x=x+1:t$=Input$(1,#1):Print #2,t$; Print @(0,0)"bytes processed";x;Space$(20) If Eof(1)=-1 Then Close 1:Close 2:End Loop the program simply copy the input file to output file byte by byte.. thank you.. Juri 2013-04-16_121454_Test.zip |
||||
TassyJim Guru  Joined: 07/08/2011 Location: AustraliaPosts: 6099 |
I have changed your test.bas slightly to speed up the process. Input "infile";a$
Input "outfile";b$ Open a$ For input As 1:Open b$ For output As 2 x=0 cls Do x=x+1:t$=Input$(1,#1):Print #2,t$; if (x mod 100) = 0 then Print @(0,0)"bytes processed";x;Space$(20) If Eof(1)=-1 Then exit loop Close 1:Close 2 Print @(0,0)"bytes processed";x;" All completed!" end Printing every 100 bytes makes a big difference to the time taken I have run the program 6 or 7 times so far without any problems. Using a UBW32 with MM Basic V4.3a and connected to a PC rather than a keyboard and screen. The schematic shows a 2.2 ohm resistor between 3.3V and pin 4 of the SD card holder. There was some discussion about this resistor and I think some users had more success if this resistor was replaced with a link. I would certainly try a different brand of SD card. Jim VK7JH MMedit MMBasic Help |
||||
 Print this page |
