TheBackShed.com

Home	JAQForum Ver 24.01
Log In or Join
Active Topics
Local Time 08:24 27 Nov 2024	Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : MM DIM "Glitch with ’S’ !"

Author

Message

Nixie
Regular Member

Joined: 19/02/2013
Location: Australia
Posts: 66

Posted: 09:49pm 04 Mar 2013

Copy link to clipboard

Print this post

((These things are to keep me sharp Geoff :-) ))

Something to be aware of:

If I enter "DIM AS(100)" and then LIST or use the EDITOR, it always comes out as
"DIM As(100)" - always lower-case 's'
Trouble is when using other commands such as PRINT AS in the same program, it can't find it because AS has been stored with the DIM statement as "As".
Doesn't seem to do it with other letters. I tried DIM AN(100) - not a problem.

Just seems to be something with the letter "S"

ALSO:

at the command prompt
AS=1 (or As=1)
PRINT AS (or PRINT As - gives the results as:)
Error: Invalid syntax in both cases
BUT
at the command prompt
AB=1
PRINT AB
1
Ab=2
PRINT Ab
2

(Biggles is still smiling grimly!)

Cheers, all - Nic.

MM_Wombat
Senior Member

Joined: 12/12/2011
Location: Australia
Posts: 139

Posted: 12:06am 05 Mar 2013

Copy link to clipboard

Print this post

Hi,

Is this because 'AS' is a reserved word. used in

open "com1:9600" As #1

or

font load "myfont.fnt" As #4

or

open "mytext.txt" for input As #1

You probably can't have a dimension statement for

TO or FOR or OR or AND or NEXT etc..

Dennis

Keep plugging away, it is fun learning
But can be expensive (if you keep blowing things up).

Maximite, ColourMaximite, MM+

Nixie
Regular Member

Joined: 19/02/2013
Location: Australia
Posts: 66

Posted: 12:15am 05 Mar 2013

Copy link to clipboard

Print this post

Ah Dennis - thanks!

That does explain it!
I can sleep tonight.

Print this page

To reply to this topic, you need to log in.