 Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me. |
Forum Index : Microcontroller and PC projects : SD Card and colour maxi
| Author | Message | ||||
Bill.b Senior Member  Joined: 25/06/2011 Location: AustraliaPosts: 226 |
Hi All I have been playing with my new CSCOLORMAXI and have found that when I remove the SD card and reinsert it the CSCOLORMAXI does not read the card unles the power is recycled. is the a problem with the CSCOLORMAXI or both the colour maximite and the CSCOLORmaxi or the type of SD card i am using. This SD card worked OK the my old maximite without and problems. SC Card - Lexar SDHC Platinum II 8 gig Bill In the interests of the environment, this post has been constructed entirely from recycled electrons. |
||||
bigmik Guru  Joined: 20/06/2011 Location: AustraliaPosts: 2914 |
Hi Bill, Without a cct I cannot be sure if Rob has designed a card inserted switch on the SD card. I can assure you though that the Colour MM can and does detect the card is inserted and replaced (it uses a microSD connector). I tried this on the UBW32-MCC PCB I designed and it indeed worked as expected. PIC Pins 82 (D5) and 83 (D6) should be GNDed when the SD card is inserted and Not write protected. Regards, Mick Mick's uMite Stuff can be found >>> HERE (Kindly hosted by Dontronics) <<< |
||||
| Bill.b Senior Member Joined: 25/06/2011 Location: AustraliaPosts: 226 |
Hi Mick The socket for the SD card on the CSCOLORMAXI is a simple design with only the 9 contacts for a standard SD card. It appears that there is no insersion switch or eject mechanisum. Bill In the interests of the environment, this post has been constructed entirely from recycled electrons. |
||||
 Print this page |
