Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 13:52 26 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : MM basic 4.0 for duinomite mega

Author Message
plasma
Guru

Joined: 08/04/2012
Location: Germany
Posts: 437
Posted: 12:51am 27 Oct 2012
Copy link to clipboard 
Print this post

Hi ppls,
Is where a MMBasic 4.0 for the duinomite with support for com3/com4 with 115200 baud ?
I have installed 3,2 which works not up to 115200 .


 
plasma
Guru

Joined: 08/04/2012
Location: Germany
Posts: 437
Posted: 08:37am 29 Oct 2012
Copy link to clipboard 
Print this post

109 viewer without a comment ?
Whats the point ?
 
bigmik

Guru

Joined: 20/06/2011
Location: Australia
Posts: 2914
Posted: 09:37am 29 Oct 2012
Copy link to clipboard 
Print this post

  plasma said   Hi ppls,
Is where a MMBasic 4.0 for the duinomite with support for com3/com4 with 115200 baud ?
I have installed 3,2 which works not up to 115200 .




I believe NOT... As Geoff has just ported the standard MM4 (mono) to the DM, therefore as the Standard MM doesnt support COM 3 and 4 or 115k baud, the port to the DM wont either.

Regards,

Mick
Mick's uMite Stuff can be found >>> HERE (Kindly hosted by Dontronics) <<<
 
TassyJim

Guru

Joined: 07/08/2011
Location: Australia
Posts: 6098
Posted: 09:42am 29 Oct 2012
Copy link to clipboard 
Print this post

I have no way of testing the Duinomite serial ports but the Change log has this:

Change log for MMBasic Ver 3.2A

Baud rates for the hardware serial ports of the DuinoMite can now be set to any speed (ie,
they do not have to be multiples of 300).

Fixed a bug that caused MMBasic to freeze when the baud rate was specified for COM3:
and COM4: (DuinoMite only).


So it is worth trying V3.2A or V4.0 to see if it has fixed your problem.
Jim
VK7JH
MMedit   MMBasic Help
 
plasma
Guru

Joined: 08/04/2012
Location: Germany
Posts: 437
Posted: 10:35am 29 Oct 2012
Copy link to clipboard 
Print this post

Ok thx a lot !
I will test it out and send my comments about later.

Thx again
 
JohnS
Guru

Joined: 18/11/2011
Location: United Kingdom
Posts: 3801
Posted: 03:51am 30 Oct 2012
Copy link to clipboard 
Print this post

I was one of the viewers but could not understand the question but in any case thought Geoff's manual would probably already say. Plus he has his own forum I believe.
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024