TheBackShed.com

Forum Index : Microcontroller and PC projects : Windows Serial Port Driver

Author

Message

lizard
Newbie

Joined: 18/06/2012
Location: Australia
Posts: 2

Posted: 04:09pm 18 Jun 2012

Copy link to clipboard

Print this post

Hi All

I am new to this so looking for some help.

I have a duinomite standard board which came with ver 2.7 of the firmware, I have also downloaded tera term, upgraded the driver as described and all was well until I upgraded to ver 3.2c of the firmware.

Now my windows 7 on my pc and vista on my laptop does not want to recognize the driver to allow tera term to see the board.

Anyone have any idea what the problem is?

donmck

Guru

Joined: 09/06/2011
Location: Australia
Posts: 1313

Posted: 06:05pm 18 Jun 2012

Copy link to clipboard

Print this post

lizard said Hi All

I am new to this so looking for some help.

I have a duinomite standard board which came with ver 2.7 of the firmware, I have also downloaded tera term, upgraded the driver as described and all was well until I upgraded to ver 3.2c of the firmware.

Now my windows 7 on my pc and vista on my laptop does not want to recognize the driver to allow tera term to see the board.

Anyone have any idea what the problem is?

Hi Len, this means basically you just turned the DuinoMite into a MaxiMite, so you need the MaxiMite serial drivers.

see:
http://www.duinomite.com/duinomite-firmware-update-guide/
for a step by step rundown on how to go about this procedure, however I am sure all the information will be available from Geoff's page at:
http://geoffg.net/maximite.html

Good luck with it.

Don...

https://www.dontronics.com

lizard
Newbie

Joined: 18/06/2012
Location: Australia
Posts: 2

Posted: 04:28pm 19 Jun 2012

Copy link to clipboard

Print this post

Thanks Don,

I have installed the firmware (DM-1-4-2012d.hex) and installed drivers, I can now use tera term again.

Cannot switch to drive b: is this normal? Edit, ignore this, found out how to do it.

I also have the olimex mod rtc, where can i find how to use this, lots to learn.

CheersEdited by lizard 2012-06-21

donmck

Guru

Joined: 09/06/2011
Location: Australia
Posts: 1313

Posted: 07:50pm 19 Jun 2012

Copy link to clipboard

Print this post

lizard said Thanks Don,

I have installed the firmware (DM-1-4-2012d.hex) and installed drivers, I can now use tera term again.

Cannot switch to drive b: is this normal? Edit, ignore this, found out how to do it.

I also have the olimex mod rtc, where can i find how to use this, lots to learn.

Cheers

If you are using the DM firmware, then the RTC should fire up when you get into "setup" and set the parameters correctly.

Don...

https://www.dontronics.com

Print this page

To reply to this topic, you need to log in.